TRIMUI Smart Pro S TG5050 Firmware Version 1.0.2 Update Log(Testing)

About Firmware release for TG5050 Smart Pro S Firmware version: 1.0.2

  • Fixed the bug where the LED switch setting was not saved when exiting a game after disabling the LED via the OSD menu.
  • Replaced the background music on the home screen and resolved the device's popping/crackling audio issue.
  • Adjusted the volume of USB audio (external DACs/Type-C headphones) and reduced latency.
  • Added a new "Performance Settings" page in the system settings, allowing mode selection for each emulator individually.
  • The CPU frequency display on the OSD menu now shows both big-core and small-core frequencies. During gameplay, you can limit the emulator's frequency by combining big/small core frequencies with performance settings to better unleash the device's performance.
  • Significantly improved ROM scanning speed. Now, automatic ROM scanning is triggered after ejecting a memory card or exiting USB card-reading mode, reducing the time needed to refresh ROMs after downloading new games.
  • Added large/small screen options for the NDS emulator: (1) Fixed stylus position calibration. (2) Removed forced HQ2x scaling; now follows the configuration file settings. (3) Most themes use Scale2x by default. Specifically, the 2nd and 3rd themes use HQ2x and Scale3x respectively. The 15th theme is optimized for 3D games, providing high-definition rendering only for the main screen. (4) Added relevant on-screen prompts.

This version is still under testing. If you have any better ideas or suggestions, feel free to leave a comment here—we will actively adopt valuable feedback and make fixes accordingly!

Back to blog

35 comments

Hi, I’d like to point out that the temperature gauge included in the home button widget isn’t working properly; it always reads 25.4 degrees. I know this problem occurs with several consoles, not just mine. You should look into it.

Alex

Hello TRIMUI Dev Team,

First of all, thank you for the release of the Trimui Smart Pro S (TG5050). It’s a great addition to the lineup!

I have two questions regarding the future software support:

Firmware 1.0.2: Is there a rough estimate or roadmap for the next firmware update (v1.0.2)? Specifically, are there plans to further optimize the UI and power management for the TG5050?

RetroArch Update: Currently, RetroArch 1.22.2 brings several performance improvements and core updates. How likely is it that the official firmware will be updated to this version, or at least provide the updated toolchain so the community can compile it?

Looking forward to your insights!

Alexander

All I need to be happy is a dolphin emulator and a properly working portmaster

Daria

Hi team,
AirPods 3 and 4 don’t reconnect at all and keep showing an error.
Also, there’s no low-battery indication — it would be helpful if the LED blinking when the battery is low.
Also remove roms operation do nothing.
Firmware 1.0.1
Thanks!

Alex

наушники блютус отключаются когда консоль уходит в сон, при возврате хочется сразу играть в игру, но приходится выходить, и подключать снова наушники по блютуз, не пойдёт так, приходится пользоваться проводными наушниками

кукиш

Leave a comment